Idiomas disponibles
Idiomas disponibles
3. Cuttheshipping s trap about 1 6in.(41cm) f rom plug end.
Look forthewords "CUT HERE." Discard e ndwiththecotter
pins. S lide remainder ofshipping strap from thepower c ord.
You willuse theremainder oftheshipping s trap later t o
secure t hedrain hose.
16"
(41 cm)
Proper connection of the drain hose will protect your floors from
damage due to water leakage. To prevent the drain hose from
coming off or leaking, it must be installed per the following
instructions.
IMPORTANT: To ensure proper installation, this procedure must
be followed exactly.
1. Check the drain hose to see if it is the proper length.
2. Wet the inside of the straight end of the drain hose with tap
water. DO NOT USE ANY OTHER LUBRICANT.
3. Squeeze ears of silver, double-wire clamp with pliers to open.
Place clamp over the straight end of the drain hose V4in.
(6 mm) from the end.
_1/4"
(6 ram)
4. Open clamp. Twist hose back and forth while pushing down
onto drain connector
at the bottom of the washer. Continue
until hose contacts the ribbed stop on the cabinet.
5. Place clamp over area marked "CLAMR" Release clamp.
1/4"
(6 mm)
For standpipe or laundry tub drain systems:
1. Open yellow, single-wire
clamp with pliers and slide over
hooked end of drain hose to secure the rubber and
corrugated
sections together.
1. Hooked end
2. Drain hose
2.
Put hooked end of drain hose into laundry tub or standpipe.
Rotate hook to eliminate kinks.
To prevent drain water from going back into the washer:
•
Do not straighten hooked end of drain hose. Do not force
excess drain hose into standpipe. Hose should be secure,
but loose enough to provide a gap of air.
•
Do not lay excess drain hose in bottom of laundry tub.
For floor drain installation, see kit number required under
"Alternate Parts."
1. Insert new flat washers (supplied) into each end of the inlet
hoses. Firmly seat the washers in the couplings.
1
2
1. Coupling
2. Washer
Connect
the inlet hoses to the water faucets
Make sure the washer basket is empty.
2. Attach the hose with the red coupling to the hot water faucet
Screw on coupling by hand until seated on the washer.
3. Attach the hose with the blue coupling to the cold water
faucet. Screw on coupling by hand until seated on the
washer.
(6 mm)
1. Drain Hose
3. Ribbed Stop
2. Clamp
4. Cabinet
8
