Idiomas disponibles
Idiomas disponibles
This section describes the available wash cycles and will help
you make the best cycle selections for your wash loads. Each
cycle is designed for different types of fabric and soil levels.
•
The washer pauses briefly throughout
each cycle. These
pauses are normal. Refer to "Normal Sounds" to learn more
about the sounds you may hear during a wash cycle.
•
Refer to "Understanding
Washer Cycles" to learn what
happens during a wash cycle.
NOTE: Use the full time for heavy soil and sturdy fabrics. For light
soil and delicate fabrics, use less time.
PERMANENT
PRESS II
Cycle Selector Control (Timer) knob
Permanent
Press II cycle
This cycle includes a load-cooling
process that reduces wrinkling
compared to other cycles. Select up to 10 minutes of wash time.
NOTE: When the timer reaches Pause, the washer will drain and
pause for no more than 2 minutes while some of the wash water
is drained and replaced with rinse water.
Ultra Clean cycle
Use this cycle for most loads to get between 6 and 16 minutes of
wash time.
Prewash
cycle
Use this cycle to get up to 4 minutes of agitation to help remove
heavy soils and stains that need pretreatment.
Prewash cycle
should be followed by an Ultra Clean or Permanent Press II cycle
with additional detergent added.
Auto Soak cycle
This cycle features 4 minutes of agitation followed by an
unlimited soak time to help remove heavy soils and stains that
need pretreatment.
You will need to reset the washer to a Spin
setting to remove water. The Auto Soak cycle should be followed
by an Ultra Clean, Permanent Press II, or Prewash cycle with
additional detergent.
NOTE: Hot water is not recommended
for soaking. It may set
some stains.
After using extra detergent in a cycle for heavily soiled clothes, or
when washing special-care
items, you may find that an extra
rinse and spin is needed.
1. Set the controls for Water Level, Water Temperature, Options
(to One Rinse), and Speeds.
2. Push in the Cycle Selector Control (Timer) knob and turn it
clockwise to any of the rinse settings.
3. Pull out the Cycle Selector Control (Timer) knob. The washer
fills to the selected water level, agitates, drains, and spins.
A drain and spin may help shorten drying times for some heavy
fabrics or special-care
items by removing excess water.
1. Set Rinse Options Control (to One Rinse).
2. Set Speeds Control:
•
For fast spin, use the Heavy Duty setting.
•
For slow spin, use the Delicate setting.
3. Push in the Cycle Selector Control (Timer) knob and turn it
clockwise to any of the Spin settings.
4. Pull out the Cycle Selector Control (Timer) knob. The washer
drains, then spins.
When the Cycle Control knob is set to a number and pulled out,
the washer fills (to the selected load size) before agitation and
timing start. The washer begins agitating immediately after filling;
agitation occurs with the washer lid down.
During agitation, the agitator creates a continuous rollover action
that provides a thorough cleaning of the wash load.
After agitation starts, the Cycle Control knob turns clockwise until
it points to an OFF area and the cycle ends.
NOTE: The washer pauses briefly throughout each cycle. These
pauses are normal for washer operation.
WASH
RINSE
1. Pitt
_
1. Pill
2. Washselected
,_
2. Rinse
time
3. Drain_No
_
3. Drain No
agitation
agitation
_j
5. Spin
The Permanent Press cycle
I
rm
I
6. Off
partially drains, fills, agitates
IILI
briefly, and drains.
13
