Idiomas disponibles
Idiomas disponibles
INSTALLATION MANUAL
18
6. OPTIONAL SETTING AND INPUT/OUTPUT SETTING OF INDOOR UNIT
Normal Mode (When unit is not operating)
1. Change to the optional setting mode
Press the "OK" switch and the "RESET" switch
simultaneously for more than 3 seconds.
2. Selection of Optional Setting Mode
"SERVICE" is
Press the "TEMP." ∨ o ∧ switch and
indicated and the
set "01" to "07". Then press the "OK"
mode number is
switch.
fl ashed.
Optional Setting Mode (Mode Number "01")
4. Selection of Optional Setting Items
In Case of Setting Other Items
5. Change of Setting Conditions
<Example> When setting 01(Increasing Fan Speed 1)
(*) Refer to the contents of the setting codes for the Table A of
"Optional Setting Items".
Normal Mode
Press the "RESET" switch in the condition of 4 or 5 to cancel the optional setting
mode.
3. Selection of Indoor Unit for Optional Setting
" 01" or "02" fl ashes.
Input / Output Setting Mode (Mode Number "02")
4.
Item Code of
Optional Setting
Select the item code
by pressing the
"TIME"
or
switch.
<Example>
When selecting C5
(Increasing Fan
Speed)
(*) Refer to Table B (Page 8) for contents of the input / output setting.
Setting Condition
5. Change of Setting Conditions
The optional setting
condition is changed by
pressing
the "OK" switch.
<Example> When setting 04 (Output: Thermo-ON for Cooling)
(*) Refer to the Table C for the contents of the input / output setting.
NOTES:
1. In case that the both indications of the "ADDS." and "RN" show "AA", the same
setting is performed to all the indoor units.
2. The address of indoor unit not connected is not indicated.
Selection of Input / Output Number
In Case of Setting Other Items
Press ∨ or ∧ switch in step 4 or 5 when selecting settings for another
unit.
Select the indoor unit to set by
pressing the "∨" or ∧" switch and
press the "OK" switch.
The address of the indoor unit (ADDS)
to set and the refrigerant cycle number
(RN) are indicated. (The left fi gure
shows the No.1 cycle and No.2 indoor
unit.)
<Example>
When selecting No.2 cycle and No.3
indoor unit.
Input / Output Number
Select the input /
output number by
pressing the "TIME"
or
switch.
<Example>
When selecting o1
(Output 1)
Contents of Input / Output Setting
The optional setting
condition is changed
(0→1→2→...) by
pressing the "OK" switch.
