Idiomas disponibles
Idiomas disponibles
CLEANING
THE UNIT
WARNING" To ovoid serious
[] personal injury,
always turn your unit off and unplug it
before you clean or service it,
Use a small brush to clean off the outside of the unit.
Do not use strong detergents. Household cleaners that
contain aromatic oils such as pine and lemon, and
solvents such as kerosene, can damage plastic housing
or handle. Wipe off any moisture with a soft cloth.
CLEANING
THE
VACUUM
BAG
1.
Empty the bag after each use to avoid deterioration
and obstructing
air flow, which will reduce the
performance
of the vacuum.
2.
Wearing eye protection and a dust mask, clean the
bag as needed. Turn the bag inside out after initial
emptying and vigorously shake out dust and debris.
3.
Wash the bag once a year or more often if needed:
a.
Remove the vacuum bag.
b.
Turn bag inside out.
c.
Hang it up.
d.
Hose it down thoroughly.
e.
Hang to dry.
f.
Turn bag right-side out and reinstall.
STORAGE
. Never store a fueled unit where fumes may reach an
open flame or spark.
. Allow the engine to cool before storing.
. Store the unit locked up to prevent unauthorized use
or damage.
. Store the unit in a dry, well-ventilated
area.
LONG
TERM
STORAGE
If you plan on storing the unit for an extended time, use
the following storage procedure:
1.
Drain all fuel from the fuel tank into a container with
the same 2-cycle fuel mixture. Do not use fuel that
has been stored for more than 60 days. Dispose of
the old fuel/oil mix in accordance
to Federal, State
and Local regulations.
2.
Start the engine and allow it to run until it stalls. This
ensures that all fuel has been drained from the
carburetor.
,
Allow the engine to cool. Remove the spark plug and
put 1 oz. (30 ml) of any high quality motor oil or
2-cycle oil into the cylinder. Pull the starter rope
slowly to distribute the oil. Reinstall the spark plug.
NOTE: Remove the spark plug and drain all of the oil
from the cylinder before attempting to start the
unit after storage.
,
Thoroughly clean the unit and inspect it for any loose
or damaged parts. Repair or replace damaged parts
and tighten loose screws, nuts or bolts. The unit is
ready for storage.
TRANSPORTING
. Allow the engine to cool before transporting.
. Drain fuel from unit.
. Tighten fuel cap before transporting.
. Secure the unit while transporting.
. Store the unit out of the reach of children.
19
