Troubleshooting; Safety; Troubleshooting Overview; Required Tools And Materials - Fronius TIG Grinder Manual De Instrucciones

Troubleshooting

Safety

Troubleshooting "Troubleshooting" is composed of the following sections
overview -
-
-
-
-
-
-
-
-
-
Required tools The following tools and materials are required:
and materials -
-
-
-
-
Compensating for Disc wear is compensated for by a fine adjustment of the length stop.
disc wear
64
WARNING! Incorrect operation may result in serious injury or damage. Do not
use the functions described here until you have thoroughly read and understood
the following documents:
- these operating instructions
- the safety data sheets for the materials used, particularly for the electrodes
to be ground
WARNING! An electric shock can be fatal. Before opening the device:
- Move the device mains switch to the - O - position
- Unplug the device from the mains
- Put up an easy-to-understand warning sign to stop anybody inadvertently
switching it back on again

Required tools and materials

Compensating for disc wear

Changing the grinding track
Draining the grinding fluid
Removing the cover plate
Changing the grinding disc
Changing the cutting wheel
Fitting the cover plate
Adding grinding fluid
Changing the digital display battery
2.5 mm Allen key
5 mm Allen key (for the grinding disc)
6 mm Allen key (for the cutting wheel)
TX25 Torx screwdriver
A container for the grinding fluid (min. capacity 500 ml)
(1)
(2)
Turn the adjusting screw (1) half a turn
1
in the specified direction to move the
stop pin (2) backward
Perform a grinding operation to test the
2
result
Keep performing steps 1 and 2 until the
3
result is satisfactory