Creating An Electrode Shorter Than 25 Mm - Fronius TIG Grinder Manual De Instrucciones

Creating an elec-
2
trode shorter than
25 mm
5
(1) (2)
(3) (4) (5)
7
Open the clamping screw (2)
1
Set the length stop to the required final
2
length of the electrode + 3 mm
(e.g. final length 10 mm = value set
13 mm)
Tighten the clamping screw (2)
3
Open the electrode holder slightly and
4
pull out more than the set length of
electrode
Insert the electrode holder into the gui-
5
de bushing (1) of the length stop as far
as the stop
This accurately sets the length of the
electrode
Tighten the back part of the electrode
6
holder
– This clamps the electrode in the
electrode holder
Introduce the electrode holder (5) into
5
the guide bushing (4) of the separator
as far as the stop
Switch on the device
6
Turn the electrode holder (5) and
7
slowly press the handle (3) down
– This cuts the electrode
Switch off the device
8
59