Creating An Electrode Of A Specific Length; General; Preparation - Fronius TIG Grinder Manual De Instrucciones

Creating an electrode of a specific length

General

Electrodes with a specific length of 92 mm or 30 mm can be created with the enclosed stop
pins.
The electrode clamped in the electrode holder is cut to the defined length by the separator
and can then be ground immediately.

Preparation

1
2
54
(1) (2)
4
(3) (4)
Place the stop pin (2) for the required
1
length into the back part (5) of the elec-
trode holder
Fix the stop pin in place with the M10
2
screw (1)
Push the electrode (3) into the electro-
3
de holder from the front as far as the
stop
Twist the front part (4) and back part
4
(5) of the electrode holder as shown
and tightly clamp the electrode
4
(5)