Creating An Electrode Of A Specific Length; Grinding The Electrode - Fronius TIG Grinder Manual De Instrucciones

Creating an elec-
trode of a specific
length
Grinding the elec-
trode
14°
(1)
3
(3) (2)
Introduce the electrode holder (3) into
1
(2) (3)
the guide bushing (2) of the separator
as far as the stop
Switch on the device
2
Turn the electrode holder (3) and
3
slowly press the handle (1) down
– This cuts the electrode
Open the knurled screw (1) and set the
1
angle adjustment (2) to the required
angle
– Read the set angle on the digital
display (3)
NOTE! The set angle corresponds
to half the tip angle.
The tip angle in the example
shown would be 28°.
(1)
Re-tighten the knurled screw (1)
2
Switch on the device
3
Introduce the electrode holder into the 4
guide bushing of the grinder
NOTE! Do not exert any pressure
on the electrode during the grind-
ing process. The weight of the
electrode holder is enough to run
the grinding process.
As soon as the electrode makes cont-
5
act with the grinding disc, turn the elec-
trode holder slowly
Grinding is completed when
- the cone of the electrode holder
touches the cone of the guide bus-
hing and
- there is no longer any grinding noi-
se
Remove the electrode holder and
6
switch off the device
55