Installation; Safety; Fitting The Length Stop - Fronius TIG Grinder Manual De Instrucciones

Installation

Safety

Fitting the length
stop
46
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described until you have thoroughly read and
understood the following documents:
- these operating instructions
- all the operating instructions for the system components, especially the safe-
ty rules
WARNING! An electric shock can be fatal. If the machine is plugged into the
mains electricity supply during installation, there is a high risk of very serious in-
jury and damage. Do not carry out any work on the device unless
- the mains switch is in the "O" position,
- the device is unplugged from the mains.
(5)
Turn the knurled nut (1) until the ban-
1
king screw (2) finishes flush with the
(1)
wide side of the stop angle (3)
Remove the clamping screw (5) and
2
the sleeve (4) from the stop angle (3)
(2)
(3)
(4)
(5)
Insert the stop angle (3) into the device
3
from the back
Fix the stop angle (3) in place with the
4
sleeve (4) and the clamping screw (5)
NOTE! Make sure that the posi-
tion indicator notch on the sleeve
(4) is at the top and that the stop
angle is at the far right (in the zero
position).
3
(3)