Idiomas disponibles
Idiomas disponibles
• Ifdesired, pull t he wire edge guide (m)
outfrom the motor h ousing until itclicks
intothelocked p osition a sshown i nfigure
10andposition thetrimmer above t he
surface a sshown i nfigure10.
• Return t othetrimming position b y
loosening thelock collar a nd rotating the
lower h ousing back 180 ° .The toot w ilt l ock
inthe trimmer position. When using the
tool, r etract thewire edge
guide totheoriginal position,
outoftheway.
UseBlack & Decker replacement
spool M odel No. A F-100.
Reload n ylon line(either bulk orprewound replacement
spool) as
shown i nthismanual.
• USE ONLY
.065 inch (1.65 mm) DIAMETER
ROUND NYLON
LINE. Do not use serrated or heavier gauge line, as they will
overload the motor and cause overheating. This line is available
at your local dealer or authorized service center.
• Other replacement parts (guards, spool caps, etc.) are available
through Black & Decker service centers. To find your local service
location call: 1-800=544-6986 or visit www.biackanddecker.com.
ZLWARNIN6:
The use of any accessory not recommended
by
Black & Decker for use with this tool could be hazardous.
CUTTING LINE/LiNE
FEEDING
Your trimmer uses .065 inch (1.65 mm) diameter,
ROUND
nylon line. During use, the tips of the nylon lines will become
frayed and worn and the special self feeding spool will
automatically feed and trim a fresh length of line. Cutting line will
wear faster and require more feeding if the cutting or edging is
done along sidewalks or other abrasive surfaces or heavier
weeds are being cut. The advanced automatic line feeding
mechanism senses when more cutting line is needed and feeds
and trims the correct length of line whenever it's required. DO
NOT BUMP unit on ground in attempt to feed line or for any other
purposes.
REPLACING
THE SPOOL (FIGURES 11,12,13)
• Unplug toot.
• Depress the tabs (n) and
remove the spool cap (o)
from the spool housing (p) in
the trimmer head (figure 11).
• For best results, replace
spool with Black & Decker
model no. AF-100.
• Grasp empty spool with one
hand and spool housing with
other hand and pull spool
out.
Replacement
spool
