DeWalt D28065 Manual De Instrucciones página 18

5.Continuously move thetoolina forward a nd FIG. 16
backward motion t oavoid creating gouges i n
theworksurface. Allowing thetool t o rest o n
the work surface without moving, ormoving the
toolina circular motion causes b urning a nd
swirling marks o nthe work surface.
6.Remove thetool f rom thework surface before
turning thetooloff.Allow thetoolto stop
rotating before s etting i tdown.
i_
CAUTION: Use extra care when working over an edge,
sudden sharp movement of grinder may be experienced.
as a
Mounting and Using Cutting
(Type 1) Wheels (Fig. 1)
Cutting wheels include diamond wheels and abrasive discs. Abrasive
cutting wheels for metal and concrete use are available. Diamond
blades tor concrete cutting can also be used.
NOTE: All grinders that use Type 1 wheels use the 1-11/16" (43 mm)
diameter quick-change backing flange (G1).
A WARNING: A closed, 2-sided cutting wheel guard is not included
with this tool and is required when using cutting wheels. Failure to use
proper flange and guard can result in injury resulting from wheel
breakage and wheel contact. See page 10 for more information.
MOUNTING CLOSED (TYPE 1) GUARD (FIG. 17, 18)
1. Open the guard latch (M). Align the lugs (K) on the guard with the
slots (L) on the gear case.
2,
3,
4,
5,
Push the guard down until the guard FIG. 17
lug engages and rotates freely in the L M
groove on the gear case hub.
Rotate guard (D) into desired working
position. The guard body should be
positioned between the spindle and K
the operator to provide maximum
operator protection.
Close the guard latch to secure the
guard on the gear case cover. You
should be unable to rotate the guard
by hand when the latch is in closed
position. If rotation is possible, D
tighten the adjusting screw (N) with
clamp lever in the closed position.
Do not operate grinder with a loose
guard or clamp lever in open position.
To remove the guard, open the guard latch, rotate the guard so
that the arrows are aligned and pull up on the guard.
NOTE: If, after a period of time, the guard
becomes loose, tighten the adjusting screw (N)
with the clamp lever in the closed position.
ACAUTION: Do not tighten adjusting screw
with clamp lever in open position. Undetectable
damage to guard or mounting hub may result.
MOUNTING CUTTING WHEELS (FIG. 9)
FIG. 18
_ CAUTION: The quick-change backing flange and threaded clamp
nut (included with tool) must be the same diameter when used with
cutting wheels.
17