Idiomas disponibles
Idiomas disponibles
B
Product usage
4.
Connect the inlet hose ends to the COLD water faucets tightly by hand, then tighten
another 2/3 turn with pliers. Turn the water on and check for leaks.
5.
Carefully move the washer to its final location. Gently rock the washer into position
ensuring inlet hoses do not become kinked. It is important not to damage the rubber
leveling legs when moving your washer to its final location. Damaged legs can increase
washer vibration. It may be helpful to spray window cleaner on the floor to help move
your washer into its final position.
Note:
•
To reduce vibration, ensure that all four rubber leveling legs are firmly
touching the floor. Push and pull on the back right and then back left of
your washer.
•
Do not use the dispenser drawer or door to lift the washer.
•
If you are installing into a drain pan, you can use a 24-inch long 2x4 to lever
the washer into place.
6.
With the washer in its final position, place a level on top of the washer (if the washer is
installed under a counter, the washer should not be able to rock). Adjust the front leveling
legs up or down to ensure the washer is resting solid. Turn the locknuts on each leg up
towards the base of the washer and snug with a wrench.
Note:
•
Keep the leg extension at a minimum to prevent excessive vibration. The
farther out the legs are extended, the more the washer will vibrate.
•
If the floor is not level or is damaged, you may have to extend the rear leveling
legs.
49
EN
