Oase AquaMax Eco Classic 2500E Manual página 13

Submerged installation of the pump
Connecting
 B
Do not plug the power plug into the socket yet!
Connect the pump according to the desired installation variant. (→ Installation variants)
• The larger the hose diameter, the smaller the friction losses in the lines and the better the
flow rate.
• The hose diameter must not be limited unnecessarily by a hose sleeve. Shorten the hose
sleeve based on the hose diameter, if necessary.
Installation
 C
• Place the pump horizontally on a stable surface.
• Ensure secure and stable positioning of the pump.
• For muddy or soiled water, we recommend installing the pump or intake-side components
(skimmer, satellite filter, base outlet, etc.) above ground level. This decreases intake of parti-
cles and increases the service life of the impeller unit.
• Only operate the pump when it is covered in at least 10 cm of water. Otherwise it may draw in
air.

The pull rope allows you to simply pull the pump from the water.
− Fasten the pull rope on the bottom filter casing through the round openings and make a
knot.
Install the unit at a dry place

For information, please refer to the operating manual.
EN
13