Idiomas disponibles
Idiomas disponibles
Spills of sugar and
other hot melted
food on glass
Dirt on the touch
controls
6. TROUBLESHOOTING
Problem
The induction hob does
not turn on
Remove them immediately
with a spatula or a suitable
scraper for induction hobs, but
be careful with the hot cooking
area:
1. Unplug the cooking hob
from the mains.
2. Hold the cookware at a
30° angle and scrape the
dirt or spillage onto a cool
area of the hob.
3. Clean the dirt or spill with
a cloth or paper towel.
4. Follow steps 2 to 4 from
the 'Usual dirt on glass'
section.
1. Unplug the induction hob
from the mains.
2. Absorb the spill.
3. Clean the touch control
area with a sponge or a
damp and clean cloth.
4. Dry the area completely
with a paper towel.
5. Reconnect the hob to
the mains if you wish to
continue using it.
Possible causes
There is no power supply.
Remove melted and sugary
-
food stains or spills as soon
as possible. If left to cool
on the glass, they may be
difficult to remove or may
even permanently damage the
glass surface.
Cutting hazard: when the
-
safety cover is retracted, the
blade of the scraper may be
sharp as a razor. Use it with
extreme care and always
store it safely and out of reach
of children.
The induction hob may beep and
turn off, and the touch controls
will not work while there is liquid
on them.
Make sure you dry the touch
control area before turning on the
hob again.
Possible solution
Make sure the hob is
connected to the mains and
it is on.
Check if there has been a
power failure. If the problem
persists, please contact the
official Cecotec Technical
Support Service.
BOLERO SQUAD I 3001
ENGLISH
69
