Carat P Serie Instrucciones página 88

Error message / error
The diamond blade is
oxide-coated
Cracks on steel core;
eccentrical wear of the
diamond blade
STEPS AFTER TROUBLESHOOTING
After completion of the troubleshooting and before switching on, follow the following steps:
1. Check for tightness all threaded joints previously detached.
2. Check proper installation of all previously removed protective devices and covers.
3. Make sure that all tools, materials and other equipment have been removed from the working zone.
4. Clean the working zone and remove any spilled substances such as liquids, processing materials or similar.
5. Make sure that all safety devices of the machine function properly.
88
Possible cause Troubleshooting
The diamond blade is Check the cooling water
overheating, too little
cooling water
Lateral friction in the cut Lower the feed rate, pull the
material slowly
The diamond blade is Use a softer diamond blade
too hard
Motor shaft bearing Replace the motor shaft
bearing
Personnel
Operating personnel
Operating personnel