Idiomas disponibles
Idiomas disponibles
Installation Instructions
B| Electrical Connections
ATTENTION INSTALLER
All electric wall ovens must be hard wired
(direct wired) into an approved junction box. A
plug and receptacle is NOT permitted on these
products.
DO NOT shorten the flexible conduit.
The conduit strain relief clamp must be
securely attached to the junction box
and the flexible conduit must be securely
attached to the clamp. If the flexible conduit
will not fit within the clamp, do not install
the oven until a clamp of the proper size is
obtained.
NOTE TO ELECTRICIAN: The 3 power leads
supplied with this appliance are
UL recognized for connection to heavier gauge
household wiring. The insulation
of these 3 leads is rated at temperatures much
higher than the temperature rating
of household wiring. The current carrying
capacity of the conductor is governed
by the wire gauge and the temperature rating
of the insulation around the wire.
WARNING:
Improper
connection of aluminum house
wiring to copper leads can result
in an electrical hazard or fire. Use only
connectors designed for joining copper to
aluminum and follow the manufacturer's
recommended procedure closely.
B1
Turn off the circuit breaker or remove
fuses to the oven branch circuit.
B2
With the oven supported on a table
or platform in front of the cabinet
opening, connect the flexible conduit
to the electrical junction box as shown
below. Position the conduit in such
a manner that it will lie on top of the
oven in a natural loop when the oven is
installed. You will need to purchase
an appropriate strain relief clamp to
complete the connection of the conduit
to the junction box.
Junction Box
Location
©
nS
WIRE
GROUND
Conduit
Strain Relief Clamp
{not included)
must be used at
Junction Box
Place oven on a
support to assist in
connecting conduit
