Briggs & Stratton 020228 Manual Del Usuario página 8

Ocultar thumbs Ver también para 020228:
Idiomas disponibles

Idiomas disponibles

Section 3: Assembly
Connect
Hose
and Water
Supply
to
Pump
IMPORTANT:
To avoid pump damage, you must assemble
the nozzle extension co the spray gun and attach all hoses
before you start the engine.
NOTE:
Remove and discard the shipping caps from the
pumps high pressure outlet and water inlet before
attaching hoses.
I.
Uncoil high pressure hose and attach one end of hose
co base of spray gun (Figure 4).Tighten
by hand.
hose here
2.
Attach other end of high pressure hose co high
pressure outlet on pump (Figure 5).Tighten by hand.
3.
Before connecting garden hose co water inlet, inspect
inlet screen (Figure 6). Clean screen if it contains
debris oi" have it replaced if damaged. DO NOT RUN
PRESSURE WASHER IF INLET SCREEN IS DAMAGED.
Inspect inlet
screen, DO NOT
use if damaged;
clean if dirty.
4.
Run water through your garden hose for 30 seconds
co clean ouc any debris.
IMPORTANT:
DO NOT siphon standing water for the
water supply.Use ONLY cold water (less than 100°F).
5.
Connect the garden hose (not to exceed 50 feet in
length) to the water inlet.Tighten by hand (Figure 6).
CAUTION
6.
Damage to equipment resulting from failure to follow this
instruction will void warranty.
Turn ON the water and squeeze the trigger on the
gun co purge the pump system of air and impurities.
WARNING
Always wear eye protection when using this equipment or in
vicinity of where equipment is in use.
Before starting the pressure washer, be sure you are wearing
adequate eye protection.
Checklist
Before
Starting
Engine
Review the unit's assembly to ensure you have performed
all of the following.
I.
Make sure handle is in place and secure.
2.
Check that oil has been added co proper level in the
engine crankcase.
3.
Add proper gasoline co fuel tank.
4.
Check for properly tightened hose connections.
5.
Check to make sure there are no kinks, cuts, or
damage co high pressure hose.
6.
Provide a proper water supply at an adequate flow.
7.
Be sure co read "Safety Rules" and "HowTo
UseYour
P_essu_eWashe _ befo e using p essu e washe_
O
loading