Briggs & Stratton 020228 Manual Del Usuario página 7

Section 3: Assembly
2. Insert carriage bolts through holes from outside of unit
and attach a plastic knob from inside of unit (Figure 2).
Tighten by hand.
3. Place accessory tray over holes on handle (viewing
from front of unit). Push the tree clips into the holes
until they sit flat against the accessory tray (Figure 3).
4. Insert mulu-colored ProjectPro Tmnozzles and other
supplied accessories in spaces provided in accessory
tray. See "How to Use AccessoryTray'.
ine Oil and Fuel
• Place pressure washer on a level surface.
CAUTION
* Refer to engine user's manual for oil and fuel fill information.
* Damage to equipment resulting from failure to follow this
instruction will void warranty.
• Refer to engine user's manual and follow oil and fuel
recommendations and insu*uctions.
NOTE: Check oil often during engine breal<-in. Refer to
engine user's manual for recommendations.
O