Briggs & Stratton 020228 Manual Del Usuario página 18

7
Troubleshooting
TROUBLESHOOTING
Problem
Pump has following problems:
failure to produce pressure, erratic
pressure, chattering, loss of
pressure, low water volume.
Detergent fails to mix with spray.
Cause
1. Low pressure nozzle installed.
2. Water inlet is blocked.
3. Inadequate water supply.
4. Inlet hose is Idnl<ed or leaking.
5. Clogged inlet hose strainer.
6. Water supply is over 100°E
7. High pressure hose is blocked or
leaks.
8. Gun leaks.
9. Nozzle is obstructed.
10. Pump is faulty.
I. Detergent siphoning tube is not
submerged.
2. Chemical filter is clogged or
cracl<ed.
3. Dirty in-line filtel:
4. High pressure nozzle installed.
Correction
I. Replace nozzle with high pressure
nozzle.
2. Clear inlet.
3. Provide adequate water flow.
4. Straighten inlet hose, patch leak.
S. Check and clean inlet hose
strainel_
6. Provide cooler water supply.
7. Clear blocks in outlet hose.
8. Replace gun.
9. Clean nozzle.
10. Contact authorized service facility.
I. Insert detergent siphoning tube
into detergent.
2. Clean or replace filter/detergent
siphoning tube.
3. See "Check In-Line Filter".
4. Replace nozzle with low pressure
nozzle.
Engine speed is too slow. Move throttle control to FAST
Engine runs good at no-load but )osition. If engine still "bogs down",
"bogs" when load is added. :ontact Briggs and Stratton service
facility.
Pressure washer stops during Out of fuel. Fill fuel tank.
operation.
O