Briggs & Stratton 020228 Manual Del Usuario página 12

Section 4: Operation
For maximum rinsing (higher pressure and lower
flow), for stubborn or hard to reach surface such
as second story surfaces, paint removal, oil stains,
rust removal or other stubborn substances (tar,
gum, grease, wax, etc.), select red Flax
ProjectPro TMnozzle (Figure 16).
4.
5.
Pull back on collar, insert new ProjectPro TMnozzle and
release collanTug on ProjectPro TM nozzle to make sure
it is securely in place.
For most effective cleaning, keep ProjectPro TMnozzle
from 8 to 24 inches away from cleaning surface. If you
get ProjectPro TMnozzle too close, you may damage
cleaning surface.
6. DO NOT get closer than 6 inches when cleaning tires.
Now to Use theTurbo Nozzle
The turbo nozzle rotates the high pressure stream in a
rapid circular pattern.Always start; the turbo nozzle at a
distance, gradually getting closer to the surface until you
get the cleaning force you want.
CAUTION
Always make sure the surface you will clean will not be
damaged by the high pressure spray by testing in a hidden area.
I.
2.
Pull back collar on quick-connect and pull current
ProjectPro Tu nozzle off. Store ProjectPro Tu nozzles in
holder provided on the accessory tray.
Pull back on collar, insert turbo nozzle and release
collar (Figure 18).Tug on turbo nozzle to make sure it
is securely in place.
To apply detergent, applies project specific cleaners
to help break down stubborn dirt and grime on a
variety of surfaces, select black ProjectPro 7M
cleaning detergent nozzle (Figure 17).
3. For most effective cleaning, keep turbo nozzle from 8 to
24 inches away from cleaning surface. If you get turbo
nozzle too close, you may damage cleaning surface.
NOTE: Detergent cannot be applied with the turbo nozzle.
Cleaning and A_ Detergent
iMPORTANT: Use detergents designed spedfica[[y
for pressure washers, Household detergents could
damage the pump.
CAUTION
* Starting the engine without all the hoses connected and
without the water turned ON will damage the pump.
* Damage to equipment resulting fl'om failure to follow this
instruction will void warranty.
4D