Bosch RA1200 Instrucciones De Funcionamiento Y Seguridad página 8

BM 2610909346 5/03 5/12/03
ATTACH ROUTER TO MOUNTING PLATE
1. Remove the black phenolic sub-base from
your Bosch router (Fig. 4).
2. If your router has its own dust extraction hood
that mounts to the top of the metal router
base and you want to use it under the router
table, this is a convenient time to install it.
3. Using the chart below, determine the
hardware (included) needed and mount type
for your Bosch router.
• For the 1601A, 1602A, 1604A, 1606A, and
the 1617 series routers, the screws are
driven into threaded holes in the router's
base (mount type 1).
• For the 1613 and 1619 series routers: the
screws go all the way through the base
and are fastened with washers and nuts
(mount type 2).
The top and front of the mounting plate is
determined by the location of the guide pin
holes. These holes are to the right of the bit
opening.
4. Refer to the mounting plate illustration (Fig.
6) on page 9, and align the appropriate
mounting plate holes for your Bosch router to
the router base holes. Make sure that the
depth adjustment controls on the router face
the front of the mounting plate.
5. Mount your Bosch router to the mounting
plate (Fig. 5).
6. Once the router has been mounted to the
mounting plate, install the desired router bit
as per the router's instruction manual.
Bosch Required
Router Model Hardware
1601A, 1602A, 4mm x 20mm phillips
1604A, 1606A machine screws (4)
1613,
1/4"-20 x 1-1/2" phillips machine
1613EVS,
screws, washers and nuts (3)
1613AEVS
1617, 10-24 x 3/4" phillips
1617EVS, machine screws (3)
1/4"-20 x 1-1/2" phillips machine
1619EVS
screws, washers and nuts (4)
11:52 AM Page 8
Router Table Assembly
REMOVE
SUB-BASE
DEPTH
ADJUSTMENT
Mount
Type
1
2
1
2
-8-
FIG. 4
FIG. 5
MOUNT TYPE 1
MOUNTING PLATE
ROUTER BASE
MOUNT TYPE 2
MOUNTING PLATE
ROUTER BASE