Bosch RA1200 Instrucciones De Funcionamiento Y Seguridad página 14

BM 2610909346 5/03 5/12/03
ATTACHING FENCE TO TABLE
Attach fence to table using the two 3/8" x 2-1/2"
carriage bolts and two wing knobs provided.
When securing the fence assembly in place, it
may be necessary to reach under the table to
provide finger pressure to stop the bolt from
spinning. Or you can tap each bolt with a mallet
so that its neck becomes slightly embedded in
the hole.
Figure 18 illustrates the assembled fence for
most operations, which uses the front set of
holes.
For making cuts in the middle of the workpiece,
such as slotting cuts, the fence can be mounted
using the rear set of holes.
Use extra caution when
WARNING
!
positioning the fence for
slotting cuts, due to the increased exposure
of the spinning bit before and after the cut.
HORIZONTAL FEATHERBOARD ASSEMBLY
The horizontal featherboard helps keep the
workpiece pressed against the fence and
reduces the possibility and intensity of kickback.
It is especially beneficial when routing small
pieces.
To install:
1. Screw a bolt into each of the two hex nuts so
that bolt heads are recessed and tightened
into the bottom of the nuts.
2. Slide the two hex nut and bolt assemblies
into the track from the right end. Attach the
second of the two matching featherboards to
the bolts using the nylon spacer washers and
small wing knobs. Position the feathers so
that they point in the feed direction (Fig. 19).
PREPARING THE ROUTER TABLE FOR
TRANSPORTATION AND/OR STORAGE
To prepare the table for transportation and
storage:
1. Remove fence.
2. Remove the mounting plate and router.
3. Fold up table legs: Make sure the cord stays
clear of the legs. Fold in the leg on the power
switch side first. Push in the leg brace lock
buttons, push leg braces in, then fold down
legs.
4. After removing the router for the mounting
plate, you can securely store the mounting
11:52 AM Page 14
Router Table Assembly
FIG. 18
WING KNOB
FRONT HOLE
REAR HOLE
WASHER
FEATHER
BOARD
plate to the router table by using the back
end of the corner snuggers (Fig. 20)
FIG. 20
UNDERSIDE
OF TABLE
-14-
3/8" X 2-1/2"
CARRIAGE
BOLT
WING
KNOB
FEED
DIRECTION
BOLT
TRACK
FIG. 19
HEX NUT
MOUNTING PLATE
SNUGGER