Bosch RA1200 Instrucciones De Funcionamiento Y Seguridad página 11

BM 2610909346 5/03 5/12/03
INSTALL ROUTER/PLATE
IN ROUTER TABLE
1. Place the router/plate assembly into the
router table. Orient the mounting plate so that
the depth adjustment controls on the router
face the front side of the table (Fig. 11).
2. Install the six nylon mounting plate leveling
screws with springs into the six holes around
the mounting plate opening. Adjust the
mounting plate height so that it is level and
SPRING
LEVELING
SCREW
FIG. 11
CONNECT THE ROUTER AND THE
ROUTER TABLE SWITCH
To prepare for use of the switch, (Fig. 12)
1. Make sure the router switch and the router
table switch are both turned off.
2. Plug the router table switch cord into wall
outlet.
3. Plug the router into the "pigtail" socket on the
router table switch.
4. Turn the router's own switch to "ON" and
activate lock-on button, if it has one.
5. Use the router table switch to start and stop
the router.
This switch has a 15 amp rating and is intended
only for turning the router "ON" and "OFF". Do
not use it to operate additional equipment, such
as a vacuum cleaner.
11:52 AM Page 11
Router Table Assembly
even with the table. A turn to the right raises
the mounting plate, and a turn to the left
lowers the plate. Mounting plate must be
level with table surface for proper
performance. Make sure that all of the
leveling screws are adjusted to be snug
against the mounting plate. (Fig. 11)
3. Assemble mounting plate snuggers using
10-24 screws and lock nuts to the four
corners of the mounting plate. To hold the
plate in position, push snuggers into corners
and tighten. (Fig. 11)
10-24 SCREW
SNUGGER
LOCK
NUT
DEPTH
ADJUSTMENT
FIG. 12
PLUG INTO
WALL OUTLET
-11-
TABLE
POWER SWITCH
PLUG ROUTER INTO
THIS SOCKET