Bosch RA1200 Instrucciones De Funcionamiento Y Seguridad página 7

BM 2610909346 5/03 5/12/03
INSTALL POWER SWITCH
Lay the table upside down on a smooth surface.
Place switch bracket's holes over pre-drilled
holes on front underside of table with the red
switch facing out. Using a No. 2 Phillips
screwdriver, drive the two #10 wood screws
through the bracket and into the predrilled holes
to affix the switch. Do not over-tighten because
this could strip the holes. (Fig. 1).
SET UP TABLE
1. Unfold router table legs until they are fully
extended and the leg braces spring into the
locked position (Fig. 2).
2. Position yourself at the front or rear of the
table.
3. Using the opening for the mounting plate and
the bottom edge of the tabletop, lift the table
to its upright position.
4. Locate the table on a level or nearly-level
surface. Stabilize the table by rotating the
leveler foot up or down until all four legs
contact the floor. The table must not be able
to rock or tilt (Fig. 3).
FIG. 3
11:52 AM Page 7
Router Table Assembly
FIG. 1
POWER
SWITCH
-7-
#10 WOOD
SCREWS
POWER
SWITCH
PREDRILLED
HOLES
TABLE
FIG. 2
LEG BRACES
LEVELER FOOT