Petsafe PBC19-10765 Manual Del Producto página 6

To Test the Bark Control Collar
Slide the Sensor Probe across a rough surface for at least 25 cm (10 in). The Bark
Control Collar should beep. If your Bark Control Collar doesn't beep during this
test, see "The Bark Control Collar does not beep" in the "Troubleshooting" section,
and continue with the second step.
Accessories
To purchase additional accessories for your PetSafe
locate a retailer near you and for a listing of Customer Care Centre telephone numbers in your area.
Component
Battery - two pack
Replacement Collar
Accessory Pack (Extra Contact Points, washers, and battery)
FREQUENTLY ASKED QUESTIONS
Will my dog stop The Bark Control Collar effectively and humanely stops most barking when
barking completely? it is worn. It should only be worn during periods of unwanted barking.
Will another dog's
No.
bark set off the Bark
Control Collar?
Will it hurt my pet? No. The static stimulation is designed to get your pet's attention, but not
punish him. The initial static correction may startle your dog; most pets will
only receive a few static corrections during normal usage.
Will the Bark Control
The Bark Control Collar is safe and effective for all breeds and sizes
Collar work for my dog?
of dogs, though it may be too large for dogs under 3.6 kg (8 lbs) to
wear comfortably.
The system should only be used with pets who are over 6 months of age.
If your pet is injured or its mobility is otherwise impaired, contact your
veterinarian or professional trainer before use.
Can I attach a lead to the
No. This can result in pulling the Contact Points too tightly against your
Bark Control Collar?
pet's neck. Attach a lead to a separate, non-metallic collar, making sure
the extra collar does not put pressure on the Contact Points.
10
Bark Control Collar, visit our website at petsafe.com to
®
Part Number
RFA-67D-11
RFA-68
RFA-118
petsafe.com
TROUBLESHOOTING
The Bark Control
• Test the Bark Control Collar (see "To Test the Bark Control Collar" section).
Collar does not beep.
• If your Bark Control Collar does not beep during this test, try the same test on
a rougher surface.
• Ensure that the battery is properly installed.
• Replace the battery.
• If the Bark Control Collar still does not beep, contact the Customer
Care Centre.
My dog keeps • Tighten the Bark Control Collar and/or trim your dog's hair where the
barking (does not Contact Points touch his neck to ensure good skin contact.
respond to the
• Test the Bark Control Collar (see "To Test the Bark Control Collar" section).
static correction).
• Replace the battery.
• Contact the Customer Care Centre.
The Indicator Light • Replace the battery.
keeps flashing.
• If the light continues to flash with a new battery, contact the Customer
Care Centre.
To Discharge the Bark Control Collar
Important: Avoid touching the Contact Points and Sensor Probe unless the Bark
Control Collar is completely discharged.
After battery removal, the Bark Control Collar retains some stored energy and
may activate 2 or 3 additional times. To completely discharge the Bark Control
Collar, slide the Sensor Probe across a table or hard surface several times, until
the Bark Control Collar stops beeping.
petsafe.com 11