Oase AquaMax Eco Premium 5000 Manual De Instrucciones página 16

Connecting the control system
 B, C
NOTE
The unit will be damaged, if water enters the plug connector.
 Connect the plug connector or place the protective cap on it.
 Ensure that the rubber seal is clean and fits exactly.
If the rubber seal is damaged, it must be replaced. When the plug connector is disconnected,

the rubber seal must be replaced if it is older than 2 years.
Always secure the plug connector or the protective cap with the two screws.

Submerged installation of the pump
Connecting
 D
Connect the pump according to the desired installation variant. (→ Installation variants)
• Ensure that the intake-side hose (IN) does not have a smaller diameter than the pressure-side
hose (OUT).
• The larger the hose diameter, the smaller the friction losses in the lines and the better the
flow rate.
• The hose diameter must not be limited unnecessarily by a hose sleeve. Shorten the hose
sleeve based on the hose diameter, if necessary.
Do not plug the power plug into the socket yet!
Installation
 E
• Place the pump horizontally on a stable surface.
• Ensure secure and stable positioning of the pump.
• For muddy or soiled water, we recommend installing the pump or intake-side components
(skimmer, satellite filter, base outlet, etc.) above ground level. This decreases intake of parti-
cles and increases the service life of the impeller unit.
• Only operate the pump when it is covered in at least 10 cm of water. Otherwise it may draw in
air.

The pull rope allows you to simply pull the pump from the water.
− Fasten the pull rope on the bottom filter casing through the round openings and make a
knot.
16
AMX0201