GE DVM1665 Manual De Instrucciones página 20

C3. ADAPTING BLOWER
FOR RECIRCULATION
NOTE: The exhaust Adapter with damper is not
needed for recirculating models. You may want
to save them for possible future use.
Remove and save screws that hold blower plate
1
and blower unit to the oven.
Blower Plate Screws
Slide the blower plate from under its retaining
2
flange and lift it off.
Retaining
Flange
3 Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust
the blower unit.
Installation Instructions
Blower Plate
Back of Oven
Blower Motor Screw
Blower Plate
20
4
Roll the blower unit 90° so that fan blade openings
are facing toward the front of the oven.
BEFORE: Fan Blade
Openings Facing Up
Roll
AFTER: Fan Blade
Openings Facing
Forward