Get Started; Connect The Baby Unit To Power; Charge The Parent Unit - Philips AVENT SCD505 Manual Del Usuario

4 Get started

Connect the baby unit to
power
You can connect the baby unit to a power
supply or insert non-rechargeable batteries to
operate it. Insert non-rechargeable batteries
to guarantee an automatic backup in case of
power supply failure.
1
Before you connect the baby unit to
a power supply, remove the lid of the
battery compartment.
2
Insert four non-rechargeable 1.5V R6 AA
batteries with the correct polarity (+/-) as
indicated.
3
Reattach the lid.
4
Connect a supplied adapter to the baby
unit and to a power supply.
10 EN

Charge the parent unit

Note
•
Make sure that the parent unit is disconnected
from the power supply and turned off.
1
Remove the lid of the battery
compartment.
2
Insert the supplied rechargeable battery
pack with the correct polarity (+/-) as
indicated.
3
Reattach the lid.
4
Connect a supplied adapter to the parent
unit and to a power supply to start
charging.
Tip
•
The battery pack only reaches the full capacity
after you charge it for four times.
• For the first 4 times, the charging time is 10 hours,
and the operating time is less than 24 hours.
•
The normal charging time is 8 hours, and the
normal operating time is 24 hours.
•
The battery indicator flashes red and a beep
occurs 30 minutes before the battery pack
runs out of power.