Diamond G77/T2BFA11 Instrucciones Para La Instalación, El Uso Y El Mantenimiento página 21

2.
Installation and any transformation for using other types of gas, must be performed by qualified technicians according
to the law in force.
See technical data tables.
WARNINGS:
Should the unit be installed against a wall, the latter must be heat resistant to temperatures of 80°C and must be fireproof.
Before proceeding with the installation, remove the protective plastic film from the relevant parts, eliminating any adhesive
residues with an appropriate cleaning product suitable for stainless steel.
Install the unit in a horizontal position; its correct levelling will be achieved by rotating the adjustable feet.
If the unit is installed by itself, it is advisable to fasten it to make its stability safer.
2.1 INFORMATION ABOUT GAS SOLID TOP OPTIMA SERIES
This manual applies to our Gas Solid Tops
OPTIMA Series, Type A
(Natural Gas and L.P.G.).
See table.
The label according to EN437 and EN203-
1-2 regulations, is located:
a) for the units with oven, on the front-
lower panel
b) for the units with no oven, in the
cabinet's low-left side
c) on the Top units, at back or inside.
Example for Italy label: Category II 2H3+
Pe= Incoming Pressure
Pi= Nozzle Pressure
2.2 LAWS, REGULATIONS AND TECHNICAL DIRECTIVES TO BE COMPLIED WITH
The following indications should be observed during installation:
- Accident and fire regulations in force
- Prescriptions by the Gas Supply Company, which should issue an authorisation before installation.
- Instructions for the "Installation of gas equipment"
- Instructions for the "Installation of electrical equipment"
- Prescriptions by the Electrical Supply Company
- Hygienic regulations.
2.3 INSTALLATION PLACE
- The unit should be installed in adequately ventilated places. (This unit requires a draft of at least 2cu.m/hr l kW T.C.
(Thermal Capacity).
- Install the equipment in compliance with the safety rules applicable in the country where the equipment is installed.
2.4 POSITIONING
- The various units may be installed individually or together with other units of our range.
- This unit is not suitable for encasing.
- The distance between side walls must be a minimum of 10cm; should the distance be less or the wall or floor material be
flammable, it is essential to use a thermal insulator.
2.5 MOUNTING THE TOP UNITS ON A BASE OR AN EXTENDING SUPPORT
All Top units are supplied with height-adjustable feet (P):
- When the unit is to be placed free on a table or a surface, tighten or loosen the feet (P) as shown in the illustration till it is
perfectly steady, then tighten the locknut (D) so that the foot is blocked. To prevent slipping, insert the rubber plugs (M)
into the feet's lower holes.
GB
Category II
1
INSTALLATION INSTRUCTIONS
20,37,50
- 20 -
MK