Mitsubishi Electric TRANE TPKA0A 1HA70 Serie Manual De Instrucciones página 8

3. Operation
3.4. Fan speed setting
<For wired remote controller>
Fri
83
Room
Cool Set temp. Auto
83
Mode Temp. Fan
RETURN SELECT
MENU
HOLD
Each pressing of the [F4] button cycles through the following fan speeds.
Auto
• The available fan speeds depend on the models of connected indoor
units.
<For IR wireless remote controller>
Press the Fan Speed button as many times as necessary while the
system is running.
• Each press changes the force. The currently selected speed is shown
at display.
Note:
The number of available fan speeds depends on the type of unit
connected.
In the following cases, the actual fan speed generated by the unit
will differ from the speed shown the remote controller display.
1. When the unit is in STANDBY or DEFROST states.
2. When the temperature of the heat exchanger is low in the heating
mode. (e.g. immediately after heating operation starts)
3. In HEAT mode, when room temperature is higher than the tem-
perature setting.
4. When the unit is in DRYING mode.
Automatic fan speed setting (For IR wireless remote controller)
It is necessary to set for wireless remote controller only when automatic
fan speed is not set at default setting.
It is not necessary to set for wired remote controller with automatic fan
speed at default setting.
1 Press the SET button with something sharp at the end.
Operate when display of remote controller is off.
blinks and Model No. is lighted A
MODEL SELECT
2 Press the AUTO STOP
blinks and setting No. is lighted B
(Setting No.01: without automatic fan speed)
3 Press the temp. buttons to set the setting No.02.
(Setting No.02:with automatic fan speed)
If you mistook the operation, press the ON/OFF
again from procedure 2.
4 Press the SET button with something sharp at the end.
and Model No. are lighted for 3 seconds, then turned off.
MODEL SELECT
en
14
7
ON
OFF
.
button.
.
button and operate
B
MODEL SELECT
A
ON/OFF TEMP
3
FAN AUTO STOP
2
MODE VANE AUTO START
5
CHECK LOUVER h
TEST RUN min
SET RESET CLOCK
3.5. Airfl ow up/down direction setting
<For wired remote controller>
3.5.1 Navigating through the Main menu
<Accessing the Main menu>
Main Main menu
Operation
ON
RETURN SELECT
MENU
OFF
HOLD
<Item selection>
Main Main menu
Initial setting
Cursor
ON
RETURN SELECT
MENU
OFF
HOLD
<Exiting the Main menu screen>
Fri
83
Room
Cool Set temp. Auto
83
Mode Temp. Fan
ON
RETURN SELECT
MENU
OFF
HOLD
<Display of unsupported functions>
Title
Not available
Unsupported function
Return: RETURN
ON
RETURN SELECT
MENU
OFF
HOLD
Press the [MENU] button on the
Main display.
The Main menu will appear.
Press [F2] to move the cursor left.
Press [F3] to move the cursor right.
Press the [RETURN] button to exit
the Main menu and return to the
Main display.
If no buttons are touched for 10
minutes, the screen will automati-
cally return to the Main display. Any
settings that have not been saved
will be lost.
The message at left will appear if the
user selects a function not support-
ed by the corresponding indoor unit
model.