Safety Equipment; Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL TC-GW 190 D Manual De Instrucciones

required edge. Move it to and fro if necessary to
enlarge the weld pool a little.
Find the ideal setting of the welding current, wire
feed speed and gas delivery rate by carrying out
a test weld. Ideally an even welding noise will be
audible. The penetration depth should be as deep
as possible, but the weld pool must not be allo-
wed to fall through the workpiece.

6.4 Safety equipment

6.4.1 Thermostat
The welding set is fi tted with an overheating
guard that protects the welding transformer from
overheating. If the overheating guard trips, the
control lamp (3) on your set will be lit. Allow the
welding set to cool for a time.

7. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
8.2 Maintenance
Anl_TC_GW_190_D_SPK9.indb 30 Anl_TC_GW_190_D_SPK9.indb 30
GB
There are no parts inside the equipment which
require additional maintenance.
- 30 -
20.07.2017 09:16:23 20.07.2017 09:16:23