Idiomas disponibles
Idiomas disponibles
Note:
• The controller automatically saves all variable values of the firing curve.
• If you do not press any keys within 20 seconds, the controller automatically reverts to the idle display. All
changes are automatically applied and saved immediately.
• Alternatively, you can exit the programming mode with the
However, changes made are automatically saved.
5.4.2.
Programming the FULL & END ramp rates
You can also program FULL and END when entering the first heating rate (Rmp
cooling rate (Rmp
).
3
FULL:
⇒ This means the fastest possible heating or uncontrolled, natural cooling with the heating elements switched
off.
⇒ The value FULL is one step above the value "999 °C/h". Press and hold the
quickly toggle between the displayed values.
END:
⇒ Ends the firing program.
⇒ The firing program ends with the respective heating or cooling rate (Rmp
If you do not enter END (program end) in the cooling rate, the temperature control in the controller is
terminated at 150 °C, and the main display then shows the end of the firing. Alternatively, you can end the
firing by pressing the
⇒ After END has been programmed, no further program steps can be selected.
⇒ The value END is one step below the value "1 °C/h". Press and hold the
quickly toggle between the displayed values.
5.5.
Starting & stopping the firing process
5.5.1.
Starting & stopping with
Step
Starting the firing process
j
Stopping the firing process
j
5.5.2.
General information
⇒
Before starting, it is recommended that you check the program values with the
⇒
If the kiln cannot follow the required increase in a controlled ramp, the controller pauses at the
temperature until the kiln has reached the required set temperature again (the indicator light above the
j
key remains lit during this time. As soon as the kiln has reached this temperature, the ramp-up
continues. As this process may occur repeatedly, the ramp-up can actually take longer.
⇒
It is also a good idea to have a written record of the contents of the firing programs kept and displayed
near the kiln, especially if there is more than one user of the kiln.
j
key.
j
Description
Start the firing process by pressing the
signalled by the lit indicator above the
Stop the firing process by pressing the
early at any time by pressing the
j
light above the
key goes out.
61 / 293 - EN -
j
key and start the firing process immediately.
), second heating rate (Rmp
1
d
f
or
) in which END was programmed.
x
d
f
or
key while entering to
j
key. The running firing process is
j
key.
j
key. You can end the firing process
j
key again. The firing in progress indicator
) or
2
key while entering to
g
key.
