Idiomas disponibles
Idiomas disponibles
No.
Display
Indicator
20
3
4
20
5
00.00
6
150
7
600
8
Meaning
Firing chamber
temperature
Go back some steps
Continue programming
Enter program delay t
0
1. Enter heating rate
Rmp
1
1. Enter switch point
Tmp
1
59 / 293 - EN -
Description
First, the current firing chamber temperature is
displayed.
h
•
Press the
key to go back one step to the
previous value.
•
To select a new program number from the
program memory, press the
back to "Firing chamber temperature (No. 3)"
X
and then press the
program memory.
•
To further customise the programming,
proceed to step #5.
g
Press the
key to select the next program
step.
d
f
•
Press the
and
program delay.
•
For technical reasons, there is a point
between the hours and minutes in the
display and not a colon, as is usually the
case with times.
•
If you do not enter a program delay or if the
"
00.00
display shows
starts immediately after you have pressed
j
the
key.
•
You can enter program delays up to
"
(h.min)
.
g
•
Press the
key to select the next program
step.
d
f
•
Press the
and
rate.
•
The ramp rate appears on the main display
as:
"
1
999
"
FULL
–
(°C/h),
END
or
(program end).
g
•
Press the
key to select the next program
step.
d
f
• Press the
and
keys to select the
temperature.
• The temperature appears on the main display
"
0
1400
"
as:
–
(°C). This depends on the kiln
model and its maximum temperature.
• If the entered temperature Tmp
the current "Firing chamber temperature (No.
3)", Rmp
and Tmp
are automatically
1
1
skipped in the firing program when the
program starts, and the controller starts at
Rmp
.
2
g
•
Press the
key to select the next program
step.
h
key to go
key to return to the
keys to select the
"
, the firing program
"
99.59
keys to select the ramp
(maximum ramp rate)
is lower than
1
