Idiomas disponibles
Idiomas disponibles
ENGLISH
3. INSTALLATION
1.
Conditions for proper ventilation
The location you choose for the installation of the freezer must be properly ventilated and
away from heat sources. Do not place the freezer near heat sources, like a hob or pot, and
avoid direct sunlight to ensure the cooling effect and save on energy consumption. Do not
place the freezer in a damp place to avoid rust or loss of cooling performance, and do not
expose it to rain.
Note:
The amount of refrigerant used by the freezer is specified on the appliance marking.
2. Installation instructions
-
Before installation, please read the instructions carefully to avoid any problems.
-
Figure 2 shows the dimensions of the mounting space.
-
Place the freezer on a solid, flat surface to keep it stable, otherwise vibrations and noises
will occur. When the freezer is placed on a carpet, straw mat, or polyvinyl chloride, solid
support plates should be placed under the freezer to avoid colour change due to heat
dissipation.
-
It is necessary to maintain unobstructed ventilation around the appliance or in the
structure where it is installed.
-
It is advisable to allow 50-70 mm of space from the back of the freezer to the wall, at least
100 mm from its upper part, at least 100 mm from its side to the wall and a clearance at the
front to allow the doors to open 135°.
3. Levelling of the device
-
For sufficient levelling and air circulation at the lower rear part of the appliance, it may be
necessary to adjust the lower legs.
-
You can adjust them manually or by using a suitable spanner (not included).
-
To allow doors to close automatically, tilt the upper part back by about 10-15 mm.
4. Installing the door handle.
Remove the handle and screws from the bag (depending on the model); then, remove the
handle cover. Place the handle cover on the right side of the door and secure it with the screws.
Fig. 3
58
BOLERO COOLMARKET TT UF 155 WHITE E
