Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
Bolt
CUTTER BLADE ASSEMBLY AND
DISASSEMBLY AND ADJUSTMENT OF
CUTTER BLADE HEIGHT
WARNING
●
To prevent accidents, ensure that the power tool
is switched off and pull out the battery.
●
Be careful not to injure your hands.
1. Cutter blade disassembly
(1) As shown in Fig. 26 use the accessory box wrench
to withdraw the three bolts used to retain the cutter
blade, and remove the cutter blade holder.
Blade holder
(2) As shown in Fig. 27, slide the blade in the direction
indicated by the arrow to disassemble the blade.
18
Blade holder
Fig. 25
Box wrench
Fig. 26
Set plate (B)
Fig. 27
2. Cutter blade assembly
CAUTION
Prior to assembly, thoroughly wipe off all swarf
accumulated on the cutter blade.
(1) Insert a turned portion of set plate (A) attached to
the blade into a groove on the flat portion of the
cutter block. (Fig. 28, 29)
Set the blade so that both sides of the blade
protrude from the width of the cutter block by about
3/64" (1 mm) (Fig. 30)
Flat portion of the cutter block
Set plate (A)
Groove
Fig. 29 (Correct installation)
3/64" (1 mm)
Blade
(2) Place the blade holder on the completed assembly,
as shown in Fig. 31, and fasten it with the three bolts.
Ensure that the bolts are securely tightened.
Set plate (A)
Fig. 28
Blade
3/64" (1 mm)
Cutter block
Fig. 30
Tabla de contenido
