Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
8. Regulating the guide (Fig. 13)
The planing position can be regulated by moving
the guide to the left or right after loosening its set
screw. The guide may be mounted on either the right
or left side of the tool.
Set screw
Guide
Work Precautions
About Continuous Operation
This tool is provided with a protective function to
extend battery life.
The battery may become overheated during
continuous operation or deep cutting operations,
which may cause it to automatically stop.
Especially with any of the batteries listed below, the
tool may stop operation before the battery starts to
get hot to prevent rapid failure from overheating.
If this happens, stop operation, remove the battery
from the tool and leave it in a well-ventilated location
not exposed to sunlight until it is sufficiently cool.
The battery can be used again once it is cool.
(Applicable batteries: BSL1825, BSL1820, BSL1815
and old batteries)
Proper Battery Usage
When the tool is used with any of the batteries listed
below, it should be used for light work to extend
battery life.
Work example: Shallow depth finishing and
chamfering work
(Applicable batteries: BSL1825, BSL1820, BSL1815
and old batteries)
CARBIDE BLADE ASSEMBLY AND
DISASSEMBLY AND ADJUSTMENT OF
CUTTER BLADE HEIGHT (FOR DOUBLE
EDGED BLADE TYPE)
WARNING
●
To prevent accidents, ensure that the power tool is
switched off and pull out the battery.
●
Be careful not to injure your hands.
1. Carbide blade disassembly
(1) As shown in Fig. 14, loosen the blade holder with
the attached box wrench.
16
Fig. 13
Blade holder
(2) As shown in Fig. 15, remove the carbide blade by
sliding it with the attached box wrench.
2. Carbide blade assembly
CAUTION
Prior to assembly, thoroughly wipe off all swarf
accumulated on the carbide blade.
(1) As shown in Fig. 16, lift set plate (B) and insert the
new carbide blade between cutter block and set plate
(B).
Set plate (B)
(2) As shown in Fig. 17, mount the new carbide blade
by sliding it on the set plate (B) so that the blade tip
projects by 1 mm from the end of the cutter block.
Box wrench
Fig. 14
Carbide blade
(Double edged blade type)
Fig. 15
Carbide blade
(Double edged
blade type)
Fig. 16
Fig. 17
Tabla de contenido
