Tabla de contenido
4-23
4-24
1
4-25
50
2
3
4
5
Layout
4.6
Laser Pointer
Figure 4-23
The machine uses the Laser Pointer to indicate the
precise point for fi tting the adhesive weights on the
F
rim (
7.0.1.1).
Note:
If the machine is set in Gauge arm mode as default, the
Laser Pointer mode can be activated by calling service.
Prolonged exposure to laser beams may damage
the eyes.
AVOID DIRECT OR REFLECTED EYE
CONTACT WITH THE LASER BEAM.
• Laser beams used in Snap-on products are rated
as Class II.
Eye protection is normally afforded by aversion
responses, including the blink refl ex.
4.7
Cameras
Figure 4-24
The various Cameras aimed at the wheel are used for
the automatic acquisition of the Distance, Diameter and
Width, as well as to perform the three-dimensional scan
of the entire surface of the tyre and rim.
4.8
Gauge arms
Fig. 4-25 Gauge arm for distance and rim diameter
1 Gauge arm, can be extended and hinged upwards
2 Weight holder to locate the adhesive weight both
for identifi cation of subsequent fi tting position and
for actual fi tting of the balance weight
3 Adhesive weight held in weight holder
4 Gauge head to identify rim dimensions on a variety
of rim profi les
5 Spring-suspended applicator.
Tabla de contenido
