Idiomas disponibles
Idiomas disponibles
Attaching Dolly
1. To attach dolly to bottom of tank, lift vacuum using the top handle. Position vacuum above
dolly with the front of the vacuum facing the front of the dolly (side with the release lever).
2. Place tab on back bottom of tank into slot in back of dolly.
3. Push downward on front of vacuum until front of tank clips into lever on dolly.
Removing Dolly
To remove dolly, gently push downward on the release lever with your foot. While holding
the release lever down, lift upwards on vacuum using the top carry handle.
DANGER
like that tend to produce arcs or sparks that can cause an explosion. Do not pick up flammable,
combustible, or hot materials. Do not use around explosive liquids or vapors, as electrical devices
produce arcs or sparks which can cause a fire or explosion - do not use at filling stations or
anywhere gasoline is stored or dispensed.
1. Refer to the filter installation and maintenance section to make sure the correct
filters are installed for your cleaning operation.
2. Replace tank cover. Make sure each latch or clamp is secured over the raised area
of the tank cover. Failure to properly secure the latches could cause the tank cover
to release from the tank.
3. Insert machine hose end with locking nut into inlet located in the front of the tank.
Turn locking nut to tighten. Do not over-tighten.
4. Attach the desired cleaning accessory onto the accessory end of the hose. NOTE: Many more useful tools
are available at your local dealer or the Shop-Vac
5. Plug the cord into the wall outlet. Your cleaner is ready for use.
I = ON, O = OFF
FILTER INSTALLATION AND MAINTENANCE
FILTRATION SYSTEM
There are a variety of filters available for your vacuum. There are cage filters that install onto the underside
of the tank cover and tank filters that install into the tank. The filters are grouped into three filtration
categories. General filtration is used for large debris; such as, wood chips, nails and gravel. Medium
filtration is used for medium debris; such as, dirt, sand and sawdust. Fine filtration is used for fine debris;
such as drywall dust, cold ash and cement dust. It is important to have the correct filters installed for your
cleaning operation to protect your vacuum motor. THE MOST EFFICIENT FILTRATION FOR YOUR VACUUM IS A
FINE FILTRATION CAGE FILTER WITH A FINE FILTRATION TANK FILTER.
NOTE: When using the vacuum to pick up very fine dust. It will be necessary to empty the tank and clean
the cage filter at more frequent intervals to maintain maximum pick up power or add a disposable filter bag.
All manuals and user guides at all-guidesbox.com
ASSEMBLY
SET UP AND OPERATION
–
This equipment incorporates parts such as switches, motors or the
website.
®
PAGE 5
