Sears Kenmore 110.20372710 Manual De Uso Y Cuidado página 15

First try the solutions suggested here for assistance and to possibly avoid a service call.
If you experience
Washer not performing as expected (cont.)
Washer won't run or fill,
washer stops working
If you experience
Washer not performing as expected (cont.)
Washer won't run or fill;
washer stops working
(cont.)
Washer not draining/
spinning, loads are
still wet
TROUBLESHOOTING
Possible Causes
Check for proper water supply.
Possible Causes
Check proper electrical supply.
Normal washer operation�
Washer may be tightly packed.
Not using HE detergent or using too
much HE detergent.
Small items may have been caught
in pump or between basket and tub,
which can slow draining.
Using cycles with a lower spin speed.
Both hoses must be attached and have water flowing to inlet valve.
Both hot and cold water faucets must be turned on�
Check that inlet valve screens have not become clogged.
Check for any kinks in inlet hoses, which can restrict water flow.
Plug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet�
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Lid must be closed for washer to run�
Washer will pause during certain phases of cycle. Do not interrupt
cycle.
Washer may be stopped to reduce suds.
Remove several items, rearrange load evenly in the basket. Close lid
and touch and hold the START/PAUSE/UNLOCK LID button�
Add only one or two additional items after washer has started.
Do not add more water to the washer�
Only use HE detergent. Suds from regular detergents can slow or
stop the washer. Always measure detergent and follow detergent
directions based on your load requirements.
To remove suds, cancel cycle. Select RINSE & SPIN. Select your cycle.
Touch and hold the START/PAUSE/UNLOCK LID button� Do not add
more detergent.
Empty pockets and use garment bags for small items.
Cycles with lower spin speeds remove less water than cycles
with high spin speeds. Use the recommended cycle/spin speed
for your item.
Solution
Solution
15