Idiomas disponibles
Idiomas disponibles
CARE AND MAINTENANCE
•
Abrasive cleaners will damage this product.
•
Never use oven cleaner to clean any part of heater
•
Do not clean any heater part in a self-cleaning oven. The
extreme heat will damage the finish.
•
More frequent cleaning may be required as necessary.
It is imperative that control compartment, burners and
circulating air passageways of the heater be kept clean.
•
Spiders and insects can create a dangerous condition that
may damage heater or make it unsafe. Keep burner area
clean of all spiders, webs or insects. Clean burner holes by
using a heavy-duty pipe cleaner. Compressed air may help
clear away smaller particles.
•
Inspect heater before each use.
•
Have heater inspected annually and repairs should be made
by a qualified service person.
•
Check heater immediately if any of the following conditions
exist:
a. The smell of gas in conjunction with extreme yellow
tipping of burner flames.
b. Heater does not reach proper temperature.
c.
Heater's glow is excessively uneven.
d. Burner makes popping noises during use.
NOTE: A slight pop is normal when burner is
extinguished.
•
Carbon deposits may create a fire hazard. Keep dome and
emitter clean at all times.
•
Do not clean heater with combustible or corrosive cleaners.
Use warm, soapy water.
•
Do not paint engine, engine access panel or dome.
•
This heater should be thoroughly cleaned on a regular
basis.
•
After a period of storage and/or non use, check for leaks,
burner obstructions and inspect for any abrasion, wear,
cuts to the hose.
Cleaning
•
Wipe surfaces clean with mild dish detergent or baking
soda.
•
For stubborn surfaces use a citrus citrus-based degreaser
and a nylon scrubbing brush.
•
Rinse clean with water.
NOTE: While cleaning the unit, be sure to keep the area
around the burner and pilot assembly dry at all times. Do
not submerge the control valve assembly. If the gas control
is submerged in water, do NOT use it. It must be replaced.
TIP: Use high high-quality automobile wax to help maintain
the appearance of the heater. Apply to exterior surfaces
from the pole down. Do not apply to emitter screen or
domes.
Maintenance
•
•
NOTE: In a salt salt-air environment (such as near an ocean)
ocean), corrosion occurs more quickly than normal. Frequently
check for corroded areas and repair them promptly.
•
Storage
Between uses or during periods of extended inactivity:
•
•
•
•
CAUTION: Wait until heater is cool before covering.
1 1
Outdoor Patio Heater
Keep exterior surfaces clean clean.
Air flow must be unobstructed. Keep controls, burner
and circulating air passageways clean. Signs of possible
blockage include:
»
Gas odor with extreme yellow tipping of flame.
»
Heater does NOT reach the desired temperature.
»
Heater glow is excessively uneven.
»
Heater makes popping noises.
Battery replacement: Use a an alkaline AAA battery.
Turn Turn control knob to "OFF".
Disconnect LP cylinder and move to a secure, well well-
location outdoors.
Store heater upright in an area sheltered from direct
contact with inclement weather (such as rain rain, sleet ,
hail, snow, dust and and debris).
NOTE: Never leave LP gas tank exposed to direct sunlight
or excessive heat.
If desired, use cover (L) to protect the heater and help
prevent buildup in air passages.
Operating Instructions and Owner's Manual
