Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
Checking For Leaks
1.
Make leakage solution by mixing 1-part liquid dish soap
and 3-parts water.
2. Spoon or brush several drops (or use squirt bottle) of the
solution onto the gas hose/regulator and regulator/cylinder
and hose connections.
3. Turn on gas cylinder valve. Inspect the connections and
look for bubbles.
a. If no bubbles appear, the connection is safe.
b. If bubbles appear, there is leakage. Loosen and re-
tighten this connection. If it still leaks, please call
customer service.
Lighting Instructions
1.
Turn the LP gas cylinder valve OFF. Push the control knob
on the pole in, turn OFF, and wait 5 minutes for any gas to
clear.
2. Turn the tank valve ON. Push control knob in and rotate
to PUSH. Then push the igniter button and control knob
until the burner is ignited. If igniting the burner for 5
seconds continuously but the burner fails to remain lit or
is extinguished, repeat step 2 after 5 minutes. Complete
shutoff period before relighting.
3. Once the burner has lit, continue to hold the control knob
in for 30 seconds, and then release.
4. Turn the control knob from LOW to HIGH until the desired
heat setting is achieved.
5. Visually check the burner flame against the illustrations to
the right:
a. Flame should be blue with slight yellow tips.
b. You should see a smaller flame in LOW position than
seen on HIGH. Perform flame check prior to each use.
If only low flame is seen, refer to "Burner flame is low"
in the "TROUBLESHOOTING".
For complete shutdown:
1.
Please turn the knob to "PUSH" position first, then push
and turn to "OFF" position for complete shut off.
2. Turn the LP gas tank valve OFF before removing the LP gas
tank.
In any case of failure of normal ignition, please use a lighter
(sold separately) to reach the burner for ignition through the
hole on the bottom of burner diffuser. Or insert a match from
the back side of the burner assembly opposite to the control
panel.
WARNING: If at any time you are unable to light burner and
smell gas, wait 5 minutes to allow gas to dissipate before
attempting to light heater.
WARNING: DO NOT touch or move heater for at least 45
minutes after use. Allow emitter and dome to cool before
touching.
WARNING: Avoid inhaling fumes emitted from the heater's
first use. Smoke and odor from the burning of oils used
in manufacturing will appear. Both smoke and odor will
dissipate after approximately 30 minutes. The heater should
NOT produce thick black smoke.
1
2
10
Outdoor Patio Heater
Operating Instructions and Owner's Manual
