TRAPP ES-500 Manual De Instrucciones página 27

www.trapp.com.br
Attention!
Frequently check if all screws are well
tightened, mainly the counter cutting
blade one. Always keep the counter
cutting blade adjusted to assure the good
performance of the shredder.
Check the status of the power supply cord. Never fix

it with insulating tape.
Never use a water jet to clean the equipment. Water

inside the equipment can damage the electric circuit
of the motor, besides increasing the risk of an electric
shock. Use a cloth soaked in neutral detergent.
Clean the cutting assembly at each operation to avoid

material buildup on the disk shaft and hammers.
Never operate the shredder with the cover open or

without the belt protection guard.
In any abnormal situation during operation, turn

off the Ensiling and contact a TRAPP Technical
Assistant.
Attention!
When the shredder is operating, do neither
put your hand inside the green crop feeder
nor in the outlet device.
Attention!
Whenever cleaning or servicing, make
sure the equipment is off and the blades
are still as they continue to move for some
seconds.
Image merely illustrative
27