Idiomas disponibles
Idiomas disponibles
Controlling:
After having addressed all FY-200, you may now start operating these via your lighting controller.
Note:
After switching on, the FY-200 will automatically detect whether DMX 512 data is received or not. If the data
is received, the control LED flashes. If there is no data received at the DMX-input, the control LED lights up
permanently.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the FY-200.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.
DMX-protocol
Control channel 1 - Horizontal movement (Pan)
Push slider up in order to move the mirrored cylinder horizontally (PAN).
Gradual mirrored cylinder adjustment from one end of the slider to the other (0-255, 128-center). The
mirrored cylinder can be stopped at any position you wish.
DMX-value
Feature
0-255
Gradual adjustment of the mirrored cylinder position from left to right
Control channel 2 - Mirrored cylinder rotation
DMX-value
Feature
0-19
No rotation
20-135
Rotation clockwise
136-139
No rotation
140-255
Rotation anti-clockwise
Control channel 3 - Colour-wheel
Linear colour change following the movement of the slider. In this way you can stop the colour-wheel in any
position.
DMX-value
Feature
0-5
Open
6-11
Open / red
12-17
Red
18-23
Red / yellow
24-29
Yellow
30-35
Yellow / blue
36-41
Blue
42-47
Blue / green
48-53
Green
54-59
Green / magenta
60-65
Magenta
66-71
Magenta / orange
72-77
Orange
78-83
Orange / purple
84-89
Purple
90-95
Purple / Cambridge blue
96-101
Cambridge blue
102-169
Rainbow effect with increasing speed
170-175
No rotation
176-243
Wave-effect (slow to fast)
244-255
Remote stand-alone music trig and auto trig
30/63
51837535_V_1_0.DOC
