Dmx-Protocol; Cleaning And Maintenance - Futurelight WL-150 Manual Del Usuario

Occupation of the DIP-switches:
Setting the DMX-
starting address:
Projector number
& channels
Device 1 - channels 1-4
Device 2 - channels 5-8
Device 3 - channels 9-12
Device 4 - channels 13-16
Device 5 - channels 17-20
Now you can start operating the WL-150 via your lighting controller.

DMX-protocol

Control channel 1 – Shutter/Dimmer
Control channel 2 – Cyan
DMX-value Feature
0-255 Cyan (0=white, 255=cyan)
Control channel 3 – Yellow
DMX-value Feature
0-255 Yellow (0=white, 255=yellow)
Control channel 4 -– Magenta
DMX-value Feature
0-255 Magenta (0=white, 255=magenta)

CLEANING AND MAINTENANCE

The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tighly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
3) Mechanically moved parts like axles, eyes and others must not show any traces of wearing (e.g. material
abrading or damages) and must not rotate with unbalances.
4) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
1
DIP-switch no.
DMX-starting
1
address
On
Off Off
On
Off
On
Off
On
Off
On
Off
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
3 5 6
2 4
16
2 4 8 32
23/45
7 8 9
64 128 256
51833565_V_1_3.DOC