Parkside PLV 1500 B1 Traduccion Del Manual De Instrucciones Originale página 31

Ensure during assembly that the
power cable is not squeezed and
that it has suffi cient play.
Assembling the handle
B
bar
1. Attach the lower bar (6) to the appli-
ance housing (8) and fasten it using
the two quick-release levers and wash-
ers (7). The smooth side of the washer
should point towards the quick-release
lever; the grooved side should point
towards the device.
2. Screw both central bars (5) with
the screws, quick-release levers and
washers (4) to the lower bar (6). The
smooth side of the washer should point
towards the quick-release lever; the
grooved side should point towards the
device.
3. Screw the upper handlebar (3) with
the screws, quick-release levers and
washers (4) to both central bars (5) to
fasten.
4. Fasten the machine cable (15) to the
bar using the machine cable terminals
(11).
Mounting and emptying
C
the collection bag
WARNING: Never operate
the implement without the
impact protector. Danger of
Injury!
The collection bag is recommended
for operation with the air roller
16)!
(
A
1. Pull the collection bag over the rods.
2. Put the plastic straps of the collection
bag over the collection bag rods and
clip into the plastic straps.
Mounting the collection bag on the
implement:
3. Lift the impact protector (13).
4. Push the pins on the collection bag
rods into the socket in the implement
case.
5. Release the impact protector so that it
holds the collection bag (12) in its po-
sition.
Removing and emptying the collec-
tion bag:
6. Lift the impact protector (13) and take
out the collection bag (12).
Operation
Please observe local regulations
concerning noise protection.
Setting the working
positions
The implement has 5 principal position set-
tings:
+10 mm :
This position sets the maximum safety spac-
ing between the tool and the fl oor.
-3 mm :
Set this position when working with a new
implement.
-3 to -12 mm : Readjustment
The working position can be lowered with
increased knife and sprung tine wear.
Wear can be identifi ed from an increas-
ingly poor result.
The readjusting depth amounts to approx.
3 mm per setting.
GB
Transport position
Working position
positions
IE
31