Idiomas disponibles
Idiomas disponibles
ADJUSTING HEIGHT OF HANDLE
1. Open the handle adjustment.
2. Move handle up or down to set desired height.
3. Close the handle adjustment.
SWITCHING ON THE VACUUM
1. Connect the main plug.
2. Switch on the vacuum at the main switch.
ROLLER BRUSH OPERATION
1. Adjust the carpet height using the carpet height
selection knob on the brush head.
2. Perform cleaning.
USING ACCESSORIES
NOTE: Vacuum with the crevice nozzle and
upholstery nozzle.
1.
Pull suction wand out of the mount. (See Figure 10)
Figure 10
2. Remove the desired accessory from the storage
compartment and attach it to the suction wand.
3. Perform cleaning. (See Figure 11)
Figure 11
Incorrect
PAGE 6 OF 28
OPERATION
SWITCHING OFF THE VACUUM
1.
2. Pull out the main plug.
CABLE STORAGE
1.
2. Wind the main cable around the cable hook and
3. To remove the cable, open the cable hook and
TRANSPORT
1.
2. Carry the vacuum by the carrying handle.
3. When transporting the vacuum in vehicles, secure
Correct
ATTENTION! Do not set the brush head with the
rotating roller to the deep-pile carpet setting
when vacuuming using the suction hose. The
carpet could be damaged or destroyed if the
rotating brush remains in the same position for
a longer period of time.
Switch off the vacuum at the main switch.
Wind the main power cable onto the winding aid.
(See Figure 12)
Figure 12
handle.
remove the cable from the handle.
Wind the main cable around the cable storage.
it to prevent it from slipping or overturning in
accordance with the respective valid guidelines.
0323 IH-10400
