Adding Component; Deleting A Component - Ottobock Genium-Bionic Prosthetic System 3B1 Instrucciones De Uso

The following points need to be observed before establishing the connection:
• Bluetooth of the component must be switched on (see Page 87).
• Bluetooth of the device must be switched on.
• The device must not be in "flight mode" (offline mode), otherwise all wireless connections are
turned off.
The device must be connected to the internet.
•
• The serial number and Bluetooth PIN of the component being connected must be known.
They are found on the enclosed Bluetooth PIN card. The serial number begins with the letters
"SN".
INFORMATION
If the Bluetooth PIN card with the Bluetooth PIN and serial number of the component is lost,
contact your O&P professional.

7.4.1 Adding component

1) Tap the symbol in the main menu.
→ The navigation menu opens.
2) In the navigation menu, tap the entry "Manage components".
3) Hold the prosthesis with the sole of the foot facing up, or connect and then disconnect the
battery charger, in order to activate recognition (visibility) of the Bluetooth connection for
2 minutes.
4) Tap the "+" button.
→ The Connection Wizard opens and guides you through the process of establishing a con­
nection.
5) Follow the subsequent instructions on the screen.
6) After the Bluetooth PIN is entered, a connection to the component is established.
→ While the connection is being established, 3 beep signals sound and the
appears.
The symbol is displayed when the connection has been established.
→ Once the connection has been established, the data are read from the component. This
process may take up to a minute.
Then the main menu appears with the name of the connected component.
INFORMATION
If establishing a connection to a component is not possible, perform the following steps:
► Delete the component from the Cockpit app if applicable (see the section "Deleting a com­
ponent")
► Add the component again in the Cockpit app (see the section "Adding a component")
Only when "DUAL" marking is present (see Page 60)
INFORMATION
After activating the "visibility" of the component (holding the component with the sole of the foot
facing up, or connecting and then disconnecting the battery charger), the component can be
recognised by another device (e.g. smartphone) within 2 minutes. If registration or establishing
the connection takes too long, the process of establishing a connection is cancelled. In this
case, hold the component with the sole of the foot facing up again, or connect and then discon­
nect the battery charger.

7.4.2 Deleting a component

1) Tap the symbol in the main menu.
symbol
79