Note the 757B35=* MyoEnergy Integral 647G1402 instructions for use.
Note the 757B20/757B21 EnergyPack 647H356 instructions for use.
We recommend charging on a daily basis. If the device is not used for an extended period, the
battery charge level should be checked regularly and the battery recharged.
1) Connect the charging plug to the charging receptacle of the product.
→ A correct connection between the battery charger and the product is indicated by feed
back (see Page 26).
→ The prosthesis is switched off automatically.
→ The charging process starts.
2) Disconnect the product after the charging process is complete.
7 Myo Plus app
With the Myo Plus app, the user can change the behaviour of the product to a cer
tain extent. The user can adapt the product to conditions on the current day and
adjust the movements through calibration. A menu item in the app allows the user
to train their muscle signal.
7.1 System Requirements
The functioning of the app is assured on devices that support the following operating systems:
iOS (for iPhone, iPad, iPod): version 9.3 or higher. The mobile device has to support
•
Bluetooth 4.0 (BT LE).
Android: version 5.0 or higher
•
7.2 Initial connection between Myo Plus app and component
The following points should be observed before the initial connection:
•
Bluetooth of the device must be switched on.
•
The serial number and Bluetooth PIN of the component being connected must be known.
They are found on the enclosed Bluetooth PIN card. The serial number begins with the letters
"SN".
7.2.1 Starting the Myo Plus app for the first time
INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the MyoPlus app.
After turning on Bluetooth, it remains active for approx. 5 minutes. The app must be started and
the connection established during this time.
1) Tap the symbol of the Myo Plus app
→ The end user licence agreement (EULA) is displayed.
2) If rights are requested the first time the app is started, these have to be granted. Otherwise
the app cannot be started.
3) Accept the end user licence agreement (EULA). If the end user licence agreement (EULA) is
not accepted, the Myo Plus app cannot be used.
4) The "Bluetooth connection" menu item is opened.
5) Tap
to establish a connection.
6) Select the desired component from the list.
7) Enter the Bluetooth PIN code and tap "Connect".
→ The
symbol is displayed when the connection has been established.
→ Once the connection has been established, the data are read from the component. Then the
radar chart is displayed.
22
.