Idiomas disponibles
Idiomas disponibles
us_main.book.book Page 21 Tuesday, September 6, 2022 9:13 AM
Tighten the 3 screws securely into the
terminal block. (approximately 35 - 50 IN-LB)
a
Black
b
White
c
Red
d
Terminal Block
e
Wire Ends
f
Ground Strap
g
Conduit Connection Plate
h
Ground Screw
i
Ground Wire
j
Bend strap up and attach.
Optional Rear Filler
Installing the Rear Filler
If the counter does not bridge the opening at the
rear wall, the rear filler kit which is provided with
the slide-in range will be needed.
NOTE
• If the countertop depth is greater than 25 3/8"
there will be a gap between the filler kit and the
back wall.
• If the countertop depth is less than 24 3/4", the
control panel will not sit flush with the
countertop.
1
Using a screwdriver, remove the three screws
holding the rear bracket
a
Vent Trim
b
Rear Bracket
2
Attach the rear bracket
assembly as shown, using the three screws
removed in step 1.
c
Rear Filler
Anti-tip Device
Installing the Anti-tip Device
Tip Hazard
WARNING
• A child or adult can tip the range and be killed.
• Install the anti-tip device to the structure and/or
the range. Verify the anti-tip device has been
properly installed and engaged by following the
guide on the anti-tip bracket template.
INSTALLATION
21
b
in place.
b
c
and filler
