Idiomas disponibles
Idiomas disponibles
Checking the battery charge level
When the appliance is switched on, the remaining
charge will be shown on the battery LED
follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Changing tools
Your cordless screwdriver has a fully automatic
spindle lock
.
When the motor is stopped, the power train locks
so that the quick-release chuck
by turning it
. After you have attached the
desired tool and tightened it by turning the chuck
you can continue working. The spindle lock is
automatically released when the motor starts
(ON/OFF switch
pressed).
2-speed gearbox
CAUTION!
►
Operate the speed selector
the appliance is at a standstill. Otherwise the
appliance can be damaged.
In first gear
(speed selector
in position 1)
you can reach a speed of approx. 350 rpm and a
high torque. This setting is suitable for all screwing
jobs.
In second gear
(speed selector
in position 2)
you can reach a speed of approx. 1300 rpm for
carrying out drilling work.
Removing the chuck
If you want to use the bit adapter
remove the quick-release chuck
Removing the chuck
♦
Hold the quick-release chuck
front.
♦
Pull/push the chuck ring
the quick-release chuck
The quick-release chuck
can be removed towards the front.
PBSA 12 F5
as
can be opened
only when
, you must
.
firmly from the
in the direction of
10a
.
is now unlocked and
Attaching the quick-release chuck
♦
To replace the quick-release chuck
the chuck ring
chuck
. Push the quick-release chuck
the bit adapter
to click the quick-release chuck
NOTE
►
If the quick-release chuck
automatically click into place, turn the chuck
ring
.
10a
Using the bit adapter
After removing the quick release chuck
use the bit adapter
,
♦
Insert a suitable bit into the bit adapter
♦
Push the bit into the bit adapter
stop.
The guidance and the magnetic holder keep the
bit firmly in place.
♦
Pull the bit out of the bit adapter
Torque selection ring/drill setting
You can set the torque using the torque selection
ring
.
♦
Select a low level for small screws or soft
materials.
♦
Select a high level for large screws, hard
materials or removing screws.
♦
Select the drill setting for drilling work by
adjusting the torque selection ring
position .
♦
Push the speed selector
work (position: 2).
towards the quick-release
10a
. Let go of the chuck ring
into place.
does not
.
as far as the
.
forward for drilling
GB │ IE
, pull
over
10a
, you can
.
to the
│
7
